Pedal box/Brake cylinder

[swe7]

Hi all.
I am building the pedal box but the drawing on page54 dont show the height
of the hole for the master brake cylinder. It looks like it is about 40mm. But If i draw a strait line from the pushrod hole in the pedal it will go down like 15mm. Is there anyone out there having foto/suggestiens of this. And i also whant to build it with the original angle on the master cylinder like Bonzo did, but i dont think that will make any differens on the height.

Peter.

[voucht]

Hi,
Are you using a Sierra or another car master-cylinder ?
If you are using a Sierra M/C, 30mm above the lower edge of the plate leaves enough room for a 8mm bolt/nut on the lower fitting hole.
Hope this will help.

[swe7]

Hi,
Are you using a Sierra or another car master-cylinder ?
If you are using a Sierra M/C, 30mm above the lower edge of the plate leaves enough room for a 8mm bolt/nut on the lower fitting hole.
Hope this will help.

Yes its a sierra M/C.

Thank you.

Peter.