I stitch welded mine James

Welded 1/2" missed 1" on the outside, on the inside I put in 1/2" stitches in the midde of the 1" gap.

It will probably warp like hell if fully welded ;)

I used a piece of 1.6mm sheet for mine, mainly because that's what I had here in stock .

i welded the plate on the side then just tacked it bit by bit worked a treat. think there are some pictures of doing it in my photo bucket somewhere

i boxed mine in both sides as it meant one less bit to edge trim for iva

what thickness cp11 did you use ash?

book says cp11 to be 1mm plate ?

can anyone confirm this cheers

Yes, thats correct, but SS1,s & the CP11,s are not needed when fitting a GRP rear tub.

cheers
andy

you sir are a star ! i was planning to cut them in the week shant bother now :)

No prob, :)

I think you are going to have your hands full this coming week, ;) :cool:

cheers
andy