Haynes Forums

Haynes Forums (http://www.haynes.co.uk/forums/index.php)
-   Announcements (http://www.haynes.co.uk/forums/forumdisplay.php?f=2)
-   -   2 quick questions (http://www.haynes.co.uk/forums/showthread.php?t=4950)

David_17 9th September 2010 08:59 PM

Only problem i've got there, is that i have 2 fuel pipes (injection). So i have my brake pipe at the bottom drivers side rail, then my fuel pipes along the 2 top rails, which leaves the bottom passenger rail for electrics, just hope that's acceptable.

Also, think my clip spacing is around 150mm :eek:


HandyAndy 9th September 2010 09:07 PM

the 2 fuel lines along the top & your electrics along the bottom will be fine for Mr IVA man, as it shows that you have tried to ensure a good spacing between these 2 functions :cool:

I would suggest adding some more "P" clips ;) , I know it appears to be "overkill" but I,m pretty sure the max between mounting points within the tranny tunnel is 100mm, & 250mm apart in other area,s of the car, taken from the paragraph in top right of page 113 of the book, tho I,ll be honest & say I,m not sure if the rules have changed from SVA to IVA, but i,ve used the book dims as my guide .

cheers
andy

David_17 9th September 2010 09:09 PM

I'll have to check that, although it seems a grey area. In the iva manual, if i remember right it just says brake pipes must be securely clipped at regular intervals. (which my pipes are). Although if there's a specific spec, then i'll need to add more. :mad:

I thought the book spacing was just as a guide. :(

HandyAndy 9th September 2010 09:20 PM

Quote:

Originally Posted by David_17 (Post 44542)
I'll have to check that, although it seems a grey area.

I thought the book spacing was just as a guide. :(

I totally agree with you Dave, I wasn,t sure of how to interpret the IVA rules, so went along with the book suggestions.

Like you say, "securely attached " is the main point.....I think "P" clips are more secure than lets say a "cable tie", so, "with you" on "your take" of the rules :confused: ;)

cheers
andy

David_17 9th September 2010 09:29 PM

I think i'll do a bit of research before fitting the panels, but i think they should be ok. (i hope) :o

flyerncle 9th September 2010 09:40 PM

The leak may be caused by a gas hole or porosity in the weld caused by contamination like oil or other muck.
I had this problem once and drilled it out and re-welded it.

David_17 9th September 2010 09:42 PM

I think i've sorted it with some chemical metal this evening. Fingers crossed. Doesn't look the best, but if it doesn't leak, i don't really mind. :D

HandyAndy 10th September 2010 10:18 AM

David............

I,ve been doing some research & found a couple of posts by Ash G who went thru his IVA with his P clips in the tranny tunnel spaced at 150mm & was all fine for his test.....& his test was a "Thorough" test :eek:

So, my apologies if I gave you duff info :o , looks like your P clip spacing should be ok;)

cheers
andy

David_17 10th September 2010 02:08 PM

phew! Thanks for letting me know Andy, nice to know it should be ok.


All times are GMT +1. The time now is 09:02 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.