Haynes Forums - few electrical queries

Page 2 of 2

Show 40 post(s) from this thread on one page

Haynes Forums (http://www.haynes.co.uk/forums/index.php)

- Electrics (http://www.haynes.co.uk/forums/forumdisplay.php?f=7)

- - few electrical queries (http://www.haynes.co.uk/forums/showthread.php?t=5252)

mr henderson

20th October 2010 10:26 PM

Quote:

Originally Posted by steve8274 (Post 47223)

would you like to enlighten me Mr henderson regarding which wire goes where for the cap :)

I did say already, one wire goes to earth, and the other to the earth side of the brake warning lamm ( Other wire to the warning lamp goes to 12V ignition switched ), so that's why I say the earth side of the lamp.

steve8274

21st October 2010 12:00 PM

Quote:

Originally Posted by mr henderson (Post 47238)

so you did. sorry missed that bit.
thanks

David_17

21st October 2010 06:03 PM

Quote:

Originally Posted by steve8274 (Post 47215)

hi david
my loom has the single green wire dedicated for reverse switch. one side is at rear for light itself and then other side just leads out of loom to connect to reverse switch

Ah right, connect that to one wire on the gearbox, and connect the other gearbox wire to 12v ignition live.

snapper

24th October 2010 01:34 PM

You can mount the megajolt in the engine bay but on a 7 the engine bay gets much hotter than a conventional car, the EDIS is known for not liking the heat, and as EDIS and jolt need to be connected with signal shielded cable I found mounting both under the dash/scuttle worked better.
Attaching a laptop for data logging is also easier with the jolt in the car

All times are GMT +1. The time now is 10:29 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page