Haynes Forums - Had a little oops...

Page 2 of 2

Show 40 post(s) from this thread on one page

Haynes Forums (http://www.haynes.co.uk/forums/index.php)

- Announcements (http://www.haynes.co.uk/forums/forumdisplay.php?f=2)

- - Had a little oops... (http://www.haynes.co.uk/forums/showthread.php?t=6320)

KAMBO

21st April 2011 09:47 PM

Quote:

Originally Posted by TheArf (Post 57483)

And doesn't that sh1t get everywhere Kambo

sure does was up to my elbows in it this morning at 6am...lol:D

monsterob

21st April 2011 10:11 PM

Quote:

i would have happily donated a tube full to the cause as we use it everyday....

well there you go .... you never made that clear in your post ;)

TheArf

22nd April 2011 08:52 AM

And many other places as well that cant be listed on here

KAMBO

22nd April 2011 04:25 PM

Quote:

Originally Posted by monsterob (Post 57353)

:eek: £40 quid he could pay someone to weld it back up !

Or the less than a tenner option cork preferably a fuel resistant rubber gasket and some bolts :)

Remember the book title ? Lol

personally i would weld it back up but if you "needed" to use sealant then i would use the above mentioned "shit" but thats only my opinion and not the law
and if i wanted to save a few hundred quid i would make my own bodywork rather than buy it ready made but i dont so i will. :rolleyes:

tex	22nd April 2011 06:23 PM

if your gonna use a gasket you must use NITRILE rubber - look in your local yellow pages under gaskets and pipework etc for industry - i got a sheet from a local industrial unit cost me a fiver for a 2 foot square.. easiest way

monsterob

22nd April 2011 07:01 PM

Quote:

and if i wanted to save a few hundred quid i would make my own bodywork rather than buy it ready made but i dont so i will.

Ooooooooooooooooooooooooooooooooooooohhhhhhhhhhhhh hhh !!!! :D

All times are GMT +1. The time now is 03:54 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page