Hi,
Just been ebaying and found this...

http://www.ebay.co.uk/itm/Custom-mad...em4ab3d7 9cc8

Johno

good frind but 48mm seems a little on the small side

I've just ordered one so I'll update you all next week when it arrives

Rapid

Just found these on the bay, i like the look of them if they turn out alright might give them a go myself.

Roll bar arrived this week and must say I'm very pleased with it. It came with the mounting plates and the ends of the tubes have already been cut at the right angle ready for welding.

All in all good value for money in my eyes and I would recommend them - no fuss quick delivery and you get what it sayes on the tin

Rapid;)

how about one with two hart shapes :D

After this was made I came across a small problem in that you can not mount the seat belt top mounts to it, if you weld threaded bosses in to the tube you can't get the bolts in. The belts would have to go on the rear suspension cage and just lay over the bottom bar. This was made in 42x3mm it is not 100% matched side to side due to the home made bender we have and it is bloody heavy, how ever I think you would struggle to damage it much more than removing the paint in the event of putting the car shiny side down.
I'd ask these guys to bend it up for you.

http://www.ebay.co.uk/itm/Custom-mad...em4ab3d7 9cc8

Scorpion do fantastic work! They custom made my cage to my spec and did a fantastic job and did not cost a massive amount too! A***** service and quality. Think they use 49mm x 3mm wall