ali seats
 

has anyone done them yet?
had a quick search but to no avail.
i have made a better net than the one in the book from card:o . at least a moor ergonomic net:) , but i can not make a decision on the thickness of aluminum to use?
are there any rules to adhere to? bare the head restraint and correctly positioned harness holes.

Try this link, these look really good.

http://www.streetperformance.com/m/c...brication.html

Thaye do look cool. Apear to be in ither .100 or .125 of an inch and grade 5052 ally. My boss thought 3mm and did not mention a hardness. Any other thoughts?

hi
leon
semi hard is ok i would ask chris about the thickness you might beable to go down to 2mm with 5000 series ally.
thwang
have you mocked one up i would mind seeing one if you have.

Have a cardbord one. Need to cross check all the meshermants and angles with trig.

I have to say im quite impressed. Can i ask how you are planning on joining the seat together if you decide to go down that route?

TIG. the seat can be folded from one peace 750x1500 and has 4 seams eatch side that i will TIG weld together.

You now have the start of a mould for a fibreglass seat Leon !:eek:

Go on? Is it just cover that in glassfiber and resin?