MX5 body removal
Has anyone done the mx5 body removal leaving the drive train etc intact?
Like this https://youtu.be/ywoHUlZTMWs If you have do you have any hints and tips? |
Quote:
http://www.mevltd.co.uk/mev/mevexocetbuildguide.pdf |
Quote:
|
If I do go down this route gonna need to document/film it
|
There are a few guides around for removal of the body of the MX5 from its powerplant and frame. They all miss a few bits out. I did mine a couple of months ago and its fairly straightforward. Keep all the nuts and bolts and plastic fasteners, you can use lots of them later, label everything you can - I haven't put the loom back together yet but I am sure all those labels will help no end. In fact label anything and everything.
Taking the body off was fine but I did everything on my own and actually dragging the body on the hoist was a bit of a struggle but its fairly straightforward. Keep the fuel tank and fuel filter - the filter bracket will save you having to make one - the tank will save you having to make the screw in fittings for the pump and level indicator. If in doubt - keep it - if not sell it. I've made about £150 profit on selling the bits I didn't need and have a free engine, gearbox, prop, electrics and instruments, can't be bad. |
I did it on my last build found it much easier that crawling undr the car trying to get the ppf seporated from the gearbox and diff
|
I have a bad back so did'nt fancy crawling under it so took the engine and gearbox out then rolled the whole thing upside down and stood up to remove every thing else with the engine crane.
|
I found it pretty straight forward as long as you remove/cut all the right bolts first.
I would probably have tried to remove all the hub nuts before this point in hind sight though. Cheers Stot |
All times are GMT +1. The time now is 06:31 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.