Build Update
 

Well after I decided to write off the ZVH off and go the zetec route it's finally in



Bit of a squeeze, tho had to remove one of the top chassis rails in the engine bay and the inlet touched the steering column



But after a bit of fettling hopefully there is enough clearance now!



This arrived today as well!

The car is now painted in primer:)

nice work James .....pleased to see someone else taking the charge cooler route, you wont regret it as it will bring the charge temps way down, much more efficient than a air/air jobby (much smaller too)

Nice one James. What colour did you decide on?

After lots of deliberation over different colours I have gone for the old favourite......white!

Bodywork now painted, scuttle and nose cone next......

Latest update:

Brought a Set of New wheels.....


And Have Trimmed the Interior.....

Nice trim job what are your internal side panels made of that you have attached the material to

Arfon

Looking good mate, must be nearly done if you're trimming the interior :)

Slowly getting there John any news on your bodywork?

I used 1" foam from dunelm to fill in between the box section and then just carpeted over it