SB4 position
 

Maybe I have overlooked this in the book, but I can't work out for the life of me where SB4 is meant to go.

It is the shortish vertical piece between the bottom rail at the back and SB3, the seat back cross brace.

CP10 mounts to it.

Any help greatly appreciated

Sean

Check out fig.4.8
on page 38
Basicly they go 178 apart from the center line from BR12 to SB3
These are important to get correct, as the diff bracket bolts to them
David

How did I miss that:rolleyes:

I looked, but just didn't see it <insert lame excuse to do with welding fumes:D>.

Thank you

Sean

Have a ...Doh !...then:D

:o wait till you get to part CP24 :D :D


andy

I already know about that one:D

I wrote it in the book when the question was answered before the forum got hacked.

Shall we leave it as a surprise?

Sean

yeah ok Sean,
tho i,ll admit i must,ve read the book page for page about 4 times before i found it :o :D

andy

You guys:rolleyes: Give me another reason to re-read the book. I will find it.

I sold the CBR! It is being picked up on Wednesday, which meens I finally have a budget £360, it may be small but it should get me some steel and a saw.

Right CP24:confused:

Save yourself £100 and just buy a hacksaw, it barely takes any time to cut the steel to a good degree of accuracy. If you dont get along with the hacksaw then think about buying a saw :D

nice one, the money you have will pay for more than you think ;) that will give you your chassis no prob.

let us know if you find out where CP24 goes :D

good luck with your build & don,t forget to enjoy it :cool:

cheers
andy