RP3 brainfart
 

For some bizarre reason I have made my RP3 tubes (the upright struts between the 2 bent rear panel tubes RP1&2) out of 19 round, rather than 19x19 erw.

They are only tacked in.

Should I bother changing them, or leave them as they are?

The only problem I can see with them 'might' be drilling into round for the rivets, if I put some there.

Sean

well rp1&2 are round & you´re going to have to drill & rivet them so why not acouple more:rolleyes: :D . i would just leave them.
samy

I did:D Back rollbar supports in as well now, so they're staying.

I think the round on round looks nicer, even though it will be covered.

Sean