![]() |
D1/U1 intersection
I cant see a clear pic in the book of D1/U1 intersect.I assume that i want to angle D1 in to get maximum contact with the U1 upright?
If anyone could post a close up pic would be much appreciated.:D |
sorry i haven,t got a pic with me but yes, you are looking for as much contact between the two meeting face,s, you might find that a little bit of steel "sticks" out at the outside edge, that you can grind off ( only about 2mm at the corner of D1 or D2 where it meets U1 or U2)
hope this helps cheers andy |
Cheers Andy,assumed this was the case and tacked it as such.Better a stupid question than a stupid mistake:p
|
All times are GMT +1. The time now is 05:01 AM. |
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.