Megajolt & Koso Dash
 

Just working on my wiring diagrams at the moment - almost done :D

Just looking at how to connect my tacho (which will be one of the Koso units) to the megajolt and I notice that a few people seem to connect the tach feed to pin 2 on the EDIS4 unit, rather than the tacho out on the MJ unit. Is this what everyone on here has done?

Cheers

Dave

You can connect the tacho to either David, the Koso unit has settings for the amount of signals received per engine revolution.

AndyH

Cheers Andy

I wasn't quite sure if that was the case as Ash mentions in this thread http://www.haynes.co.uk/forums/showt...light=megajolt that he had to use pin 2 and he is using a Koso dash.

I also notice from your saturn store that your RX2n is noticeably cheaper than some of the other popular sellers. I know where I will be coming to buy mine :p