Opinion wanted on Flywheel
 

Hi all,

I have been reading up on the forum about connecting a 2ltr zetec engine (mine is a silver top) to a type 9 gearbox and the general concensus is the following:

1.8 ltr Zetec flywheel (because it is lighter)
1.8 mondeo clutch
CT133 release bearing

I have found the following flywheel on ebay Link Here

Would this be a suitable for my intended application?

Cheers in advance,

Jonathan

1.8 flywheel is needed because its thinner than the 2L.
Type 9 bellhousings don't fit over a 2L jobbie (well some do, some dont)

Your suggested setup there is the way to go.

Not sure about that ebay one as I cant see the other side.

Cheers for that.

If I ask for a picture of the otherside, what is it that I am looking for to know if it is suitable?

Cheers,

Jonathan

1.8cvh fits im told and is lighter again but has no trigger teeth so you need to fit a trigger wheel