zetec flywheel from a mk1 focus
 

Hi all,

still looking at flywheels for a zetec to type 9 setup. Have found loads of flywheels for the 1.8 zetec focus. So my question is whether or not this flywheel will work?

thanks in advance,

Jonathan

Yes that should be ok, im using a 1.8flywheel/mk1 mondeo clutch kit/ct133 release bearing and its fine

No issues whatsoever simple bolt together stuff

Cheers,

I already have most of the rest of it, just trying to make sure I get the right flywheel.

Then I can get it all together. :)

Mine was from a silvertop to be exact, i was going to reuse the cvh one from my old set up as its lighter, but i went for the zetec flywheel in the end so i didnt have to mount a trigger wheel on the bottom pulley for megajolt