RU8 10mm or 20mm?
 

I remember a thread in the forum stating that according to the book drawings for the rear upright, the driveshafts should be shorthened and the next easier solution was to use a 20mm thick RU8 plate instead.
It took me much time searching for this but with no luck.
Anyone could help? Thanks!

longer arms was the fix in the newer book but some have moded the uprights to get round the old spec arms

I have made the rear wishbones according to the new book and also i have welded on a 20mm instead of a 10mm thick RU8 plate.. So, is that wrong? :confused:

check the dimentions of the rear arms to the the amendment section stickyed in anouncements
the book orignaly had arms that where too short for std sierra shafts so the book was updated
if you made the longer arms you dont need the extra 10mm if you made the shorter type you need the extra 10mm :D