[Badger]

Minor update: got a couple of hours in so fabricated\modified my exhaust mounts to support my beefy cans (hur hur hur). Got both sides done, so just (just!) the headers to do on the RHS and then I'll set about fully welding it. Wanted to get both sides done before fully welding in case something needed modifying, and to allow me to spread the welding out and hopefully limit warpage due to heat.






Also the bent components for the roll cage arrived, but numpty here managed to give the wrong dimensions for the rear roll bar. That'll teach me for doing it in a hurry! Don't suppose anyone wants an extra-width rear roll bar?