[Badger]

So it's been a while again since an update; I've been busy but it's all been little bits really. This is the summary:

Got the inlet manifolds made up (I used Alu-Weld to join the tubes to the plates since my TIG welder couldn't put enough heat into it), modified the throttle bodies to accept bosch style injectors, made up some spacers and then assembled it all on top of the engine. An easy summary but there was a fair bit of detailed work involved! Also got the throttle cable set up sorted for now - I expect I'll have to tweak it a bit in the future (especially if I make some cam covers), but for now it proves that the throttle pedal has sufficient travel and both sets of bodies open equally.