Sometimes you have to go backwards a bit to go forwards... after straightening up the front hoop I cut off the rear rail and pockets in order to gain enough access for the roll cage rear stays.
I made up some plates so the for the rear stays and welded them in.
Because the garage has a relatively low roof and the car is quite high on the build tunnel I'm having a hard time judging the position of the roof bars, so for now these will stay tacked only until I get it on the floor to have a proper look at it. I nearly got the rest of the welding finished last weekend, just a couple more bits to do and then I'm onto the cooling and fuel systems.
Need to get the seats in (if only temporarily) so I can make the harness mounts and I need to weld in a bracket to support the throttle cable and hold it clear of the exhaust. Also the garage needs a bloody good clean - it seems like it takes no time at all for everything to get covered in crap and dust
