Rear Wheel Clearance
Hi
I fitted my rear wheels last weekend. While I was fitting them I notice that the bottom wishbone and upright have very little clearance between the rims. The rolling chassis touches the rim in places.
I have reduced the threaded bar to the shortest length possible, however I have maintained the washers on each end as I assume this retains the bush tubes. I have not get fully tightend the hub nuts. I am hoping that when tightend this will rectify the issue but did not want to use the nyloc until final assembly.
Do I need to either?
1) Buy larger rims?
2) Make ali spacers to increase the distance by 5-10 mm?
3) Tighten the hub nuts as the nylocs will not make any diffrence if already self tapped?
Has anyome else had similar issues?
|