Quote:
Originally Posted by HandyAndy
i found that spacers were needed on the lower & upper brackets that get welded onto FF2 & FF3.
hope this helps, there are other threads in the chassis section discussing this also.
cheers
andy
|
Thanks, but today i finally planned on getting those suspension brakets on, when i had completely overlooked the fact that i should have 13mm holes in the jigs where the m12 studding goes through. I dont have a drill at home that has a chuck bigger than 10mm, and dont have any drill bits bigger than that
. I think i may endup going to screfix or equivlant tomorrow to buy a new drill and bits as i completely forgot that my drill chuck only goes to 10mm
, but i guess a new drill will do me good in the long run
