Right - have a look at these. It would seem that with some nifty joggling you can use only two plates to do the front and rear. They are quite big pieces of plate, but I will get them laser cut with the rest of the platework so shouldn't be too expensive. They will do all the suspension mounts, you just need to then sort out the shock mounts. The idea is to use studding to accurately set the back and forth alignment and a few little spacers will make life easier
These are still a concept at the moment and not tested, but if anyone wants a drawing or even the DXF files to try them they are welcome but you do so at your own risk
Front Setup
