Hi geeman,
i,m using the 1.8cvh engine & i also had to make up an engine mount for the drivers side so as to allow the steerong column to fit,
i used the original ford alloy mount for the passenger side & used the original rubber mounts on both sides.
i can post some photos later tonight of engine position etc,
as for the gearbox position, basically you can use the reversing light switch on the drivers side of the gearbox as a guide to the forward post tranny tunnel upright next to your left leg (sorry haven,t got the book with me).
the gearbox position then dictates the engine position.
if you look in the thread "big day" in the chassis section there are some photos of my engine/gearbox fitting.
cheers
andy
