Quote:
Originally Posted by andyuk697
well i tacked in place then put on top and plan to fully weld round the exposed sides that are left if this is suitable i will carry on as i dont fancy taking it all appart again lol
im looking at getting the 19mm tube for the rear and the plates for the chassis plates next what should i get? i cant seem to find any thinkness of plate in the book 
thanks Andy |
Andy
Most of the chassis plates are 3mm. If you look at the technical drawings at the back, they state "3 Plate", or in certain cases "1 plate" (cp17 as an example) There are also 5mm and 10mm plates needed
Hope that helps
PS - the 5mm and 10mm bits, it's well worth getting them from 3GE, it's a pig to cut. I did my own diff plates in the 5mm and it was a learning experience.
I bought the 10mm bits from 3GE.
Next time
I'm buying a plasma cutter
Sean