Hi Ray
You may remember, my chassis had a light coat of rust !!??
This was all wire brushed using mainly a twisted wire wheel in the grinder, hand brush & production paper for the hard to get to areas.
I gave the chassis 2 coats of Galvafroid, this was put on with a small radiator roller & 1/2' brush.
Then applied a 3 light coats of smooth Hammerite by spray. I used a small touch up gun with a large fluid tip ( This will avoid paint wastage )
If Hammerite is thinned correctly, it will spray OK.
Went with Red, just to be different
Although the more I look at it, the more I am not liking it
It'll end up black or silver
