View Single Post
  #4  
Old 28th October 2009, 06:51 PM
davidimurray's Avatar
davidimurray davidimurray is offline
Senior Member
 
Join Date: Jan 2009
Location: Near Cardiff
Posts: 742
Default

I have just been drawing some - haven't made any yet but will get around to it at some point. I've made them to the exhaust port shape + 1.5mm to allow for a tube to be swaged out to fit. You're welcome to a copy of a DXF but I would make a cardboard prototype before you get any cut.

Also if anyone has a drawing for a pinto inlet flange that would be much appreciated - b***dy hard thing to draw!
Reply With Quote