i drilled the floor except the areas where the side pannels go on and held with clecos. i then removed the floor, applied tiger seal then fixed back in place with rivets. i used bits of wood and g clamps to clamp down the areas where the side pannels would go over later on while the tiger seal set.
once all the tiger seal had gone off i put the side pannels on then drilled through the side pannels and the floor. then riveted.
little note to all. i made my side pannels prior to fitting the floor but sitll managed to get them on with a pry bar and rubber mallet.
i must have done something right as the floor is still attached
|