Quote:
Originally Posted by GraemeWebb
Just done a dummy first fit of the engine and box. Sump will have to be modded. Clearence is tight on the side rail and hight of the motor too high so I will have to chop a piece out.
Can someone help with the dimmension from the engine/gbox flange to the top engine bay upper chassis rail when using a Pinto/ Zetec etc.
As an assides the the top of rocker cove to side chassis rails id 230 mm with the sump 25 mm below the bottom rail. A tall motor.
|
Can anyone help with the dimension from the engine/gbox flange to the top engine bay upper chassis rail when using a Pinto/ Zetec etc.
I would like to get the Beemer engine in the same place if posible.