Thread: Exhaust???
View Single Post
  #4  
Old 19th February 2010, 02:56 PM
davidimurray's Avatar
davidimurray davidimurray is offline
Senior Member
 
Join Date: Jan 2009
Location: Near Cardiff
Posts: 742
Default

No reason why you couldn't ..... but firstly I expect the flow characterstics would not be that good. It could also be quite difficult to manufacture, bends etc. If your looking to save space, then the critical parameter will be the cross sectional area. As the flowrate of the gas will be the same up both exhausts, the cross sectional area will dictate the gas velocity which is the key performance parameter. If you take a 35mm diameter pipe has a CSA of 962mm2, then you need a 31mmx31mm square to match that CSA.
Reply With Quote