I,ve used a metal "P clip" rivetted just where the white cable tie in the above photo is, rivetted to the inside face of SB4 , this holds the fuel line a little higher above the BR12 rail,
looped the fuel line up a little then another metal P clip on the back face of BR12 ( the face you can see in the above pic), then followed along the inner face of RS1 till it met the tank.
The metal p clips are the rubber shrouded ones by the way.
Seems ok to me, doesn,t touch any part of the chassis & is above the lowest point of the chassis rails so won,t get caught going over bumps etc.
cheers
andy
|