Quote:
Originally Posted by HandyAndy
now that you have more detailed info to what is incorrect on the chassis.....
You say the back end is out, is that just the 2mm extra length between BR10 to BR12 ?
Are the angles of the the seat back frame ( SB1 etc ) correct?
If so then you might be able to "save " the chassis by removing everything forward of BR10, maybe even re using some of the cut out tubing, & maybe having a new front frame, now that you have the build table all marked out you can then correct everything to book spec.
cheers
andy
|
looking at it i would need to cut off everything in front of sb1 etc, the cp's for the shock/roll bar mounts need to come off, the rear panel has been made of box and has square corners, this would only leave the seat back and rs section that i can't be sure is any good without cuting and more mesurements.
to be honest my trust in anything made as it should is just not in me any more.
its more of a case of fresh start
the last thing i need is finding more probs later down the line.
theres nothing like the old sayings mesure twice cut once, check and doubble check then check it again to be sure, jig it clamp it keep it there and only tack it then weld it at the end when your doubble sure
thoes of us only know what happens if we dont
you only have to heat a bit of tube and watch it bend with the expansion
