Ok,
So I have reset the tyre pressures to 20 at the front and 18 at the back.
I have also redone the toe in to 1.5deg .
Seems a lot better.
Still room for improvement.
Might try a little more toe in.
Someone mentioned bumkpsteer.
Not quite sure about this, had a look at the rack to see how it lined up.
It s dead level looking from the front.
But looking down from the top, the rods go forward towards the wheels.
Have a look at the dodgy sketch. Angle not as bad as pic, just done it like that to show what I mean
If I lower the rack on the mounts it will improve the angle forwards but make it worse looking from the front
(Does that make sense?)
Is it worth altering, or am I starting to loose the plot??
The rear end is pretty good, very little toe in.
Perhaps 1/2 a deg and no camber