Quote:
Originally Posted by John Marchant
Fab looking car. If mine comes out anywhere near that I will be a happy bunny. Silly question, the rollbar, is that designed for the fibreglass rear end and if so does it not have two brace struts. If everyone else is reading this and laughing, sorry, I am new to this.  |
Hi John,
Thanks, the 2 cars do look good together, Spuds car being finished & on the road & mine.......well.........it,ll be finished for this summer
Do you mean the back braces of the roll bar on my car? if so, then I have yet to fit them, I purposely waited until I had my seats so that I can weld in the cross brace at the correct height for the seat to seat belt upper mounting point, as this is specific to height from seat squab etc etc for the IVA test.
Once the cross brace is in I,ll be welding the back braces into place, tho mine are in a different position to that of Spuds car ( personal preference ) as they go from the bend of the roll hoop down to the outside corners of the chassis base.
The back braces on spuds car are as book spec when fitting an ali rear tub but spud adjusted his GRP tub to accept them.
My own car has different rear chassis arrangement which is to accept the GRP tub, which is how your kit will be supplied.
hope this info helps?
cheers
andy