Quote:
Originally Posted by Andy J
Thanks for the reply Andy much appreciated the bit that is confusing me the most is the 26 degree cut At 290mm Ie which way the Tube should sit to get my 75mm
thanks
Andy
|
Yes, this can be a little confusing, as the way the front frame jig is positioned , its almost like a negative of a photogragh in the way the "brain" tries to see the layout
BUT
If you make your front frame jig, then place FF1 & FF4 into position, then cut both compound angles (26/14 degree,s) on both FF2 & FF3 (opposite handed) then offer each part upto the jig, it,ll make it easier "to see" how each 26degree notch is facing, then once they are both done, bend the tube at the notch point then cut the 14degree cut at the top.
If you get really stuck, i,ll cut FF2 & FF3 for you & post them to you
( not trying to hard sell you anything, just trying to help
)
cheers
andy