[TheArf]

Thanks for the good wishes, steel was delivered this afternoon, while I was waiting looked over some of the drawings for the chassis and here comes the first question for the wise gentlemen of the forum. Looking at the intersection of A1,B2 and D1 is there any reason why A1 could not be made 25mm shorter and B2 made 25mm longer. I am asking this as I think that you may get a stronger weld rather than butting A1 and D1 end to end, I may also be talking a load of twaddle, if this is doable you could also encorporate it on the other juntions such as D1,C and F1, and also the mirror welds on the opposite side.

Arfon H