Cheers Ronnie, your new website is looking interesting. I look forward to following it.
Attached should be three photos of the fanimold after initial welding and as it is currently. The third picture is a bit glary but it shows how I've built up "buttresses" around the fixing holes 'cos they were too close to the sides of the transfer tubes to allow for bolt heads. I've built them up with weld, drilled them through then I'll mill the tops flat and use cap headed bolts to fix it. There's still loads of tidying up and polishing to do but its coming along nicely.
I'll leave it up to you lot to decide if its a candidate for automotive porn or would be better consigned to the scrap bin and get Ronnie to do it properly
.
D.