Thread: Rear panel
View Single Post
  #2  
Old 14th September 2010, 09:43 PM
Enoch Enoch is offline
Senior Member
 
Join Date: Nov 2009
Location: Near Boston, Lincolnshire
Posts: 788
Default

I used a Sikaflex equivalent on mine and pop rivetted at each end and also in to the uprights between the curved bars. I rounded over top and bottom, I think the results were worth the effort, it looks really quite neat. I cut my panel long so that I had about 5mm over the edge of the diagonal at the rear of the wheel - ie where the panel ends. This enabled by to pein the edge over and give it a nice finish.
Enoch
Reply With Quote