Quote:
Originally Posted by ACE HIGH
Enochs advice is bang on,
Also it takes less than 30 seconds to cut through 25x25x1.6 so dont waste you money on any fancy saws,a hacksaw is the best way to go about it.
Nothing wrong with being 1mm over in length and tidying it up.
WARNING pushing hard on a blunt blade will cause it to break and spear off broken bits at your face so safety glasses always with a hacksaw'
Finally you young studs,stop being so soft,30/40 years ago I often cut 3/4.and 1 inch steel with a hacksaw and thought nothing of it.David  |
Thanks Ace - But remember, you're all made of far better stuff over there - just take a look at the All Blacks !!
