Quote:
Originally Posted by Spikehaus
As for the scuttle position, I just lined the front of the GRP up with the rear of the cross member. I guess I will not know the final position until I have the bonnet! Its just a screw slots to alter it.
|
The bottom corners of the dash line up with the chassis uprights. The fiberglass scuttle is longer than the book spec, so lining up the front edge doesn't work.
Just letting you know, as if you get it wrong and start attatching wires to it, may cause problems. Also, the dash may need altering (my scuttle expanded slightly at the dash side as it came out the mold.
Hope that helps a bit..
Dave
__________________
~
My Build Diary -
http://davesroadster.blogspot.com/
*updated 7/6/11*
Best bit so far: Getting it running
Worst bit so far: Cutting steel for wishbones and engine mounts.
Most annoying bit so far: Generator packing up half way through welding.