Front Suspension Brackets
I've made a jig for the front lower suspension brackets.
The dimension in the book is 494 for the spacing between holes across the width of the chassis.
With this spacing and the correct height off the build board the brackets dont' touch the front frame uprights by a few mm either side.
Anyone else had this problem?
I could bring the brackets in a few mm either side (Say 490mm spacing) so they sit flush with the front frame uprights. That way the track width at the front of the car will just be reduced a couple of mm both sides, no real issue.
Just curious if others have had the same problem, the front frame was pre built so hoping quite accurate.
Mike
|