Well I've now completed the sump alterations and hopefully there should be some photos attached to this posting. I cut 35mm out of the sump pan using a demolition reciprocating saw with a coarse metal blade fitted, to hold the sump while I cut it I clamped it to the front rail of the Dragon. I re-used the front and sides of the piece I cut out to extend the mid section to retain a similar volume to the original, I reckon I'm probably about half a litre shy of the original which I don't think will cause too much of a problem as its not really going to be a race car.
Once I'd welded the base back on and the extension pieces on I cut out the section where the sump pan goes down at the front (photos will explain better than words) and then welded on a piece of 3mm ali sheet to close the whole sump off. Inside I drilled three 8mm dia holes in the pan base to prevent air locks. I filled it with water and found a couple of pin holes just as Ash did so just went over them again. The sump plug had been butchered in the past and was a real mess so I turned the head down in the lathe so that it was a nice fit in a 12mm nut which I then welded onto the plug so it now has a nice big 19mm hex head.
D.
|