Quote:
Originally Posted by brainbug007
I'm working on this bit as well at the moment but I'm a little confused by the top part of the frame. It looks like RS7 & a should go underneath the cross rail on the seat back section but it looks like there will be a small "wedge" of space between RS7 & a and the seat back rail? Is that right or have I messed up an angle somewhere??
|
You,ve got it spot on BB, RS7 & RS7a go UNDER SB3, remembering to leave 3mm at the front face of SB3 so that when you weld on the CP2 plates its all flush with the angle of SB3 for when you come to fit the seat back panel,
You are correct, there is a small void where the end of RS7 & RS7a meet the CP2 plates, this is due to the SB3 part being canted back 17degree,s where as RS7 & RS7a are positioned horizontally, ( hope that makes sense )
Have a look at the lower sketch drawing of Fig 4.15 on page 43, you can see what I mean about the 17 degree angle of SB3 in relation to RS7 & RS7a.
cheers
andy