[Pavel]

Right, I'm still CADing my chassis but have just attached the uprights, wishbones etc. to the chassis.

I get silly camber (over 5 degrees). I can't for the life of me figure out why this is, as I've used book dimensions for everything.

Could somebody confirm the following dimensions (in square brackets are what I've got):

1) From chassis pivot axis of lower front wishbone to centre of lower ball joint [414.50mm]

2) From chassis pivot axis of upper front wishbone to centre of upper ball joint [260mm]


I'm sure I've got the geometry wrong somewhere, but need to narrow it down.


Thanks,
Pavel