Quote:
Originally Posted by shh120m
good idea andy, i didnt think about that. Its turning into abit of a head scratching mission this! Does the scuttle sit ontop of TR2? If so would it be possible to angle the top of the end of the new rail in and remove a small section of the bottom of the scuttle to fit around it if you know what i mean?
|
Sorry Nathan, my bad
What I meant to say was the "Engine bay bulkhead" sits between TR8 & TR9 & then the bonnet over the top, depending if you leave the return flange thats on a GRP bonnet then that would sit on top of TR2, tho you could cut a notch out of the bonnet return flange so that it misses the new steel you,ve installed,
Yes the scuttle sits on top of TR2 / TR1.
Nice work
cheers
andy