Right im back! Had a house move so all the gear was stored in the garage. Also found the garage roof had a rather large leak so now thats all sorted i can start to do things again. Happy days! Now live next to people so cant be loud so going to have to rethink things a little. Have started getting the engine to a finished state as its the only thing i can get to at the moment
Have been thinking about the chassis as when i removed the workbench i noticed it had sagged a little in the center so a bit worried my chassis might be a bit screwed up as did not notice it when i was welding. Im very tempted to look for someone to take the chassis too just to check it over and install/weld the suspension brackets. Maby Saturn or someone, im unsure so thought i would ask if any of you guys have done this? Also as its a few inches stretched would like to check if its all ok.
Here are a couple of pics of the engine now i have installed all the correct bits to hold the covers on. Also i found a Oil filter housing that did not have a heat exchanger(Saves a load of space and loads of hoses) so that was imported from japan.
