Quote:
Originally Posted by AshG
first i tacked then welded all the bottom rails fully so i had a solid base then worked upwards fully welding in stages.
|
Same here Ash
When i laid out my chassis base rails, I could see that the unwelded joints sitting on the build table were likely to cause some distortion issues later on
Tacked my base up well, lifted it from the table & flipped it over to confirm it was all square, then fully welded the entire base section ( Linishing the bottom welds to allow it to sit flat on the table.
I won't go into detail of the rest of my fabrication process, It'll only start a whole bunch of arguments !!??
