Quote:
Originally Posted by will_08
No they sit at a right angle, then when you add the top frame to it should mate with SB3 perfectly.
Unless the lean back of the whole frame is not quite right, which is what i had.
|
Thanks for the comments. Strangely the lean back angle was the problem I had the first time round (build #1). On build #2 (Revenge of the chassis) I have measured all angles with an inclinometer so they should be pretty close).
The way I see it, I have two options:
1. Remake RS2 a little longer (about 4mm), so the back is square. (But is this likely to have any knock on effects?)
2. Live with the angle being slightly out (which is bothering me at the moment as it seems excessive).
Thoughts?
Thx
Martyn