Ok I had a quick look this morning. The two wires on the dash are brown/yellow and brown/green and sit about 1/2 way along the plug. The brown/yellow goes into a pin that has another brown/yellow as well (eg 2 wires into the same pin). There aren't any pins on the plug that don't have a wire. I did forget to check for the 2,4,c number so I'll check that tonight.
I also checked the edis, and again I don't have any pins which don't have a wire. If the rev counter would normally run off the edis (I think you said it was a green wire?) I guess I just need to trace where all the wires are going and just move/bypass something to complete the circut between the edis and the dash?
|