All great suggestions / ways of cutting the steel
As you are cutting by hand, here is an easy way to cut the compound mitre cuts......hope it helps ( its a little long winded to write down & to read but it works )
Lets use the bottom compound mitre cut on FF2/FF3 as the example.....
firstly cut the 26 degree cut....
Place the steel down so the 26 degree cut is facing down onto the workbench,
then
Scribe the 14degree angle onto the upper face of the steel ( eg..top right to bottom left as you look at it )
then
turn the steel over 2 flats(away from you ) ( so now onto the original bottom from the first position of the steel on the bench )
then
scribe the 14degree angle from bottom right to top left as you look at it
then
turn the steel BACK 1 flat(towards you) ( in effect on its side from original position ) & using a straight edge line up the points of the previous 2 scribe marks & scribe a line.
You should now have 3 scribed lines showing the compound angle of 14 degrees.
Place the steel in a vice in position to cut the 2nd scribed line you made, you will find it easier to cut if the steel is positioned in the vice at an angle downwards ,
then using a hacksaw or ( depending how confident you feel...and angle grinder with a 1mm cutting disk ) & cut that scribe line ( do NOT cut all the way thru the 3 faces of the steel, just cut that 1 scribe line )
then
Remove the steel from the vice & turn over 2 flats towards you ( you,ll be cutting the 1st scribed line you made ) , position the steel so it is pointing upwards, then cut that scribe line ( again do NOT cut thru any other faces of the steel ),
then
remove the steel from the vice & turn the steel 1 flat AWAY from you & position the steel in the vice angled slightly downwards & cut the scribed line.
You should now have a perfect 14degree compound mitre cut , use a file to smooth out the cut lines so they all run in 1 direction of the compound cut.
Don,t forget that all the compound mitre cuts on the chassis apart from SW1 & SW3( these are singular pieces within the chassis) that have duplicates ( eg SB5 & SB6, FF2 & FF3 etc) are "handed".
hope this helps, & I hope it makes sense
.....it does work
cheers
Andy