Quote:
Originally Posted by Johno
Hi Bob,
Haven't seen that thread but will look.
Is this what you plan to do on your front wishbones as the American Locost boys use this type of setup as well and seem to have no problems.
I guess this gives you some adjustment on your caster to help with centering right?
I like the idea of that especially with the ability to alter camber without removing the ball joint.
I've came up with a neat (hopefully) solution similar to the photo regarding camber adjustment for IVA and was also thinking about using Heim joints for caster (after Algas thread) but is it ok to mix and match poly bushes with Heim joints as my front lowers are poly now as below.....
Cya all soon
Johno |
On the cobra I built with xj12 suspension they press a needle roller bearing into the rear wishbones. They are as cheap as chips and if the right diameter could be found may be a cheap alternative. I will get the bearing book out and investigate.They might even do the bearings in yellow.
Bob